Operation; Simple Operating Functions - HomeMatic HM-RC-12-B Operating Manual

If no teaching occurs, teach mode is automatically ended after
20 seconds. If other devices are in teach mode, these are taught.
Successful teaching is indicated with flashing green (the length
depends on whether the configuration is still running).
Note: If the remote control is already taught for a center and
therefore is blocked for direct training, it can still be put
in teach mode as described above, the device LED is
illuminated in red for 2 seconds after pressing an operat-
ing button however.
Direct teaching is not possible!
Min. 2 sec green LED
2 sec red LED
Orange flashing
Brief orange flashing
and 2 sec red or green
(depending upon suc-
cess)
Remote control in con-
figuration mode and
illuminated red with
button actuation
7

Operation

7.1

Simple operating functions

After teaching, simple operating functions are available.
The 12 buttons are taught as 6 separate button pairs (ON/OFF)
for one receiver upon delivery, depending on from which pair the
button was pressed for teaching. Switch actuators and dimmers
can then be switched ON/OFF or dimming occurs by holding the
button pressed. The blind actuators move up or down.
Teaching successful
Teaching failed
Only remote control in teach mode
Other device in teach mode and
remote control put in teach mode.
Remote control already taught for
center and is therefore blocked
from direct teaching
27