Behavior After Changing Batteries; Teaching - HomeMatic HM-RC-12-B Operating Manual

6.1.3

Behavior after changing batteries

After inserting the battery, the remote control will run a self-test.
This runs for approx. 2 seconds.
The initialization runs next. The completion is indicated with the
LED test display: red, green, orange, each for a half second. If an
error occurs, it is indicated with red flashing!
One long flash, two short
flashes, pause
(repeated 2 times)
One long flash, one short
flash, pause (infinite)
If the battery power is low, as long as the power level allows,
the button actuation is activated and the remote control is ready
for operation. Depending on the requirements, the battery may
recover and send again many times after a short break. If the
power drops too low when sending, the respective error code is
displayed again.
6.2

Teaching

Please read this section completely before starting with any
teaching!
The remote control supports three different modes
• Operation mode (normal operation)
• Configuration mode (for changing remote control pa-
rameters)
• Teach mode (Teaching Homematic components)
Training requires that both devices to be connected are put into
teach mode and the desired channel is selected for training.
Battery power too low
Remote control defective
25