AT&T CL84367 Complete User's Manual page 60

Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
If you have one handset, press and hold
f f
If you have more than one handset:
f f
w Press
FLASH
enter the destination handset number.
-OR-
w Press q
CID
handset number, then press
/PTT.
FLASH
The telephone base shows Connecting to HANDSET
X... (HANDSET represents the handset name, X
represents the destination handset number) for a
few seconds. When the connection is made, both the
telephone base and destination handset display
Press and hold [PTT] to talk.
2. Press and hold
microphone is on. Speak towards the telephone base.
Your voice is broadcast to the destination handset.
While you are speaking, the telephone base shows
PTT To handset: X.
3. Release
FLASH
and the screens show Press and hold [PTT] to talk. Then, you can
press and hold
can respond (see Answer a PTT call on page 56).
4. To end the PTT call, press CANCEL. The telephone base shows
Push to talk Ended for a few seconds.
/PTT, then, use the dialing keys to
or p to highlight the destination
DIR
/PTT. A chirp indicates your
FLASH
/PTT
after speaking. Both devices beep once again
/PTT to continue speaking or the destination device
FLASH
FLASH
/SELECT or
MENU
54
/PTT.
PUSH TO TALK
>HANDSET
fffff
Connecting to
HANDSET X...
fffff
Press and hold
[PTT] to talk
fffff
PTT To
handset: X
fffff
p
X
q