Fax Tx Report; Density; Duplex (Only On Models With A Duplex Scanning Function.) - Kyocera ECOSYS M2635dn Operation Manual

Sending Faxes > FAX TX Report

FAX TX Report

You can check whether FAX was transmitted properly by printing the report after transmission.
Item
Off
On
Error Only
NOTE
This setting is displayed if FAX TX Result Reports is set to [Specify Each Job].
Send Result Reports (page 7-4)

Density

Adjust density.
(Value: [-4] to [+4] (Lighter to Darker)))

Duplex (Only on models with a duplex scanning function.)

Select the type and orientation of the binding based on the original.
Item
1-sided
2-sided
Orig. Binding
Orig. Orientation
Does not print reports.
Prints reports.
Prints reports only if an error occurs.
Value
―
―
Left/Right, Top
Top Edge Top, Top Edge Left
3-21
Description
Description
Disables the function.
Select the [OK] key to scan the original with the default setting.
For the default settings, refer to the following:
Machine's Operation Guide
Select [Detail] to display the [Orig. Binding] screen.
Select the binding direction of originals, and select the [OK]
key.
Select the orientation of the original document top edge to
scan correct direction, and select the [OK] key.