Fax Direct Transmission; Cancelling Direct Transmission; Fax Tx Report - Kyocera Triumph-Adler 302ci Operation Manual

Sending Faxes > FAX Direct Transmission

FAX Direct Transmission

The destination is dialed and communication starts before the original is scanned, allowing you to verify that each page
of the fax has been properly sent.
Setting for Direct transmission
On
Off
NOTE
In direct transmission, you can designate only one destination for one transmission.
In the basic screen for sending, select [Direct]. This selects the direct transmission method and the keys on the touch
panel are highlighted.

Cancelling Direct Transmission

During direct transmission, to cancel communication during transmission, select the [Stop] key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
NOTE
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.

FAX TX Report

You can check whether FAX was transmitted properly by printing the report after transmission.
Item
Off
On
Error Only
NOTE
This setting is displayed if FAX TX Result Reports is set to [Specify Each Job].
Send Result Reports (page 7-4)
Starts direct transmission.
Dials the receiving system, and after the communication has started, originals are
scanned.
Starts memory transmission.
After originals are scanned into memory, the communication starts.
Does not print reports.
Prints reports.
Prints reports only if an error occurs.
3-21
Description
Description