Future light DMH-200 User Manual page 42

to be followed that this manual can only give in part. The operator must therefore inform himself on the
current safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the safety rope hole on the bottom of the base. Pull the
safety bond over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
Screw one clamp each via a M10 screw and nut onto the Omega-holders.
4
The Moving-Head can be placed directly on the stage
floor or rigged in any orientation on a truss without
altering
drawing).
For overhead use (mounting height >100 cm), always
install an appropriate safety bond.
You must only use safety bonds and quick links
complying with DIN 56927, shackles complying with
DIN EN 1677-1 and BGV C1 carbines. The safety
bonds, quick links, shackles and the carbines must
be sufficiently dimensioned and used correctly in
accordance
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or
industrial areas, a series of safety instructions have
DANGER TO LIFE!
2
1
3
42/64
its operation characteristics
with the
Insert the quick-lock fasteners of the first Omega-
holder into the respective holes on the bottom of
the device. Tighten the quick-lock fasteners fully
clockwise. Install the second Omega-holder.
(1) Omega-holder
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
(see the
latest industrial safety
00107960, Version 1.0