Table of Contents
Advertisement
Quicksilver 755SD — System & Component Overview and Operation
Fuel burning open flame appliances consume cabin oxygen
and release products of combustion into the craft.
Ventilation is required when appliances are in use. Open
designated vent openings while appliances are in use. Do
not use the stove or oven space heating. Never obstruct
ventilation openings.
Do not use solutions containing Ammonia.
Changing LPG Cylinders
To replace empty LPG cylinder:
1. Turn off the stove and close the shutoff valve.
2. Close the valve on the LPG cylinder.
3. Remove the regulator by turning the nut clockwise.
4. Replace the empty tank.
5. Inspect the regulator. Make sure that the gasket located on the regulator nut is in good
condition. If not, replace regulator gasket or regulator itself.
6. Re-install and tighten the regulator by turning the nut counterclockwise.
7. Check for any leaks before restarting the stove.
9. Bow Anchor Windlass (optional)
The anchor windlass located at the bow of the boat assists with the anchoring of your boat by
automatically raising and lowering the anchor. The windlass is operated from the helm.
Operation
To operate the windlass, the windlass breaker, located on the battery switch panel, must be turned
ON. Operation of the windlass at the helm is controlled by a momentary switch used to raise and
lower the anchor. Pushing down on the switch will lower the anchor, while pushing up on the switch
raises the anchor.
Anchor Windlass
Bow windlass
Windlass breaker
Windlass switch
If a leak is detected, shut off the main LPG supply valve and
do not use LPG appliances
Do not use an LPG system that has leaked until it has been
inspected and repaired by a competent person.
Never use flames to check for leaks.
29
Advertisement
Table of Contents
