Table of Contents
Advertisement
2.5.7
Scanning Barcode, 1D laser version
To use the scanning function, complete the following steps:
1.
If you have not already done so, remove the protective plastic film
before using devices equipped with a laser scanner.
2.
Select Start > Settings > Control Panel > Barcode Setting. Con-
figure settings as described in "Barcode Setting" on page 53.
3.
Start WordPad.
4.
Aim the scanning beam at the center of bar code.
– Position the device close to bar code when scanning
– Position the device further away when scanning larger bar
codes.
– The scanner is disabled after you release the key or after five
seconds.
5.
Press the right/left/central scan key. The scanner scans as long as
you hold the key or for five seconds.
6.
Upon reading a bar code, the red LED indicator comes on until the
trigger is release or five seconds. The green LED and the beep tone
indicate a good read.
MARS-1030F User Manual
44
Advertisement
Table of Contents
