Future light EYE-740 QCL ZOOM User Manual page 47

Brand Show
With this function you can show or hide the brand name 'FUTURELIGHT' on the display.
Key lock
With this function you can lock the keys of the Control Board to e.g. prevent menu tampering. If this function
is activated, the keys will be automatically locked from the last command. In order to deactivate or
temporarily deactivate the keylock function, press the keys in the following order: ↑ UP, ↓ DOWN, ← LEFT,
→ RIGHT and ENTER to regain access to the menu commands.
Language select
With this function, you can select the desired display language.
Fixture Set
Silent mode
With this function, the fan power and the brightness are reduced making the fixture quieter.
PWM (Pulse-width modulation)
With this function you can select the PWM frequency of the LED to 600 Hz, 1200 Hz, 2000 Hz, 2400 Hz,
4000 Hz or 25000 Hz.
Users
User mode
With this function, you can create user defined channel orders.
Edit User
With this function, you can adjust the preset user definition.
Calibration
With this function, you can calibrate and adjust PAN/TILT, R/G/B to their correct positions. The password for
this function is „050".
Fixture ID
RDM
With this function, you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when
the device is installed in a remote area.
RDM is integrated in the DMX-transmission line without influencing the connections. New DMX-cables are
not necessary. RDM ready and conventional DMX devices can be operated in one DMX line. The RDM
protocol sends own packages in the DMX512 data feed and does not influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
Wireless Set
With the function "DMX on cable", you can loop-through the DMX signal via DMX cable and with the
function "Reset Connect", you can log out the projector from the wireless sender.
Ethernet Set
With this function you can set the necessary menu settings for the use of the Art-Net protocol.
IP Addr
With this function the IP address of the device can be adjusted and changed as required.
IP MASK
With this function the subnet part of the unit's IP address can be adjusted.
47/52 00127396, Version 1.0