Table of Contents
Advertisement
Table 5 Status Screen (continued)
LABEL
DESCRIPTION
NAT Session
This field displays what percentage of the VMG supported NAT sessions are currently being
Usage
used. This field also displays the number of active NAT sessions and the maximum number of
NAT sessions the VMG can support.
Interface Status
Interface
This column displays each interface the VMG has.
Status
This field indicates the interface's use status.
For the LAN and Ethernet WAN interfaces, this field displays Up when using the interface and
NoLink when not using the interface.
For a WLAN interface, this field displays the enabled (Up) or disabled (Disable) state of the
interface.
For the DSL interface, this field displays Down (line down), Up (line up or connected) ,Drop
(dropping a call) if you're using PPPoE encapsulation, and NoLink when not using the
interface.
For the 3G interface, this field displays Up when using the interface and NoDevice when no
device is detected in any USB slot.
Rate
For the Ethernet WAN and LAN interface, this displays the port speed and duplex setting.
For the DSL interface, it displays the downstream and upstream transmission rate.
For the WLAN interface, it displays the maximum transmission rate or N/A with WLAN
disabled.
For the 3G interface, this field displays Up when a 3G device is installed in a USB slot and N/A
when no device is detected in any USB slot.
Chapter 5 Network Map and Status Screens
VMG3925-B10C/B30C User's Guide
74
Advertisement
Table of Contents
