Table of Contents
Advertisement
Figure 26 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -Bridge
Mode)
The following table describes the fields in this screen.
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -Bridge
Mode)
LABEL
DESCRIPTION
General
Active
Select Enable or Disable to activate or deactivate the interface.
Name
Enter a service name of the connection.
Type
Select ADSL/VDSL over PTM as the interface that you want to configure. The VMG uses the VDSL
technology for data transmission over the DSL port.
Mode
Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN
This section is available only when you select ADSL/VDSL over PTM in the Type field.
Active
Select Enable to activate VLAN on this WAN interface. Otherwise, select Disable to deactivate.
802.1p
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater
the number, the higher the priority level.
802.1q
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
OK
Click OK to save your changes.
Cancel
Click Cancel to exit this screen without saving.
If you select ADSL over ATM as the interface type, the following screen appears.
Chapter 6 Broadband
VMG3925-B10C/B30C User's Guide
85
Advertisement
Table of Contents
