Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 38 DNS Route Add
LABEL
Active
Domain Name
Subnet Mask
WAN Interface
OK
Cancel
9.4 The Policy Route Screen
Traditionally, routing is based on the destination address only and the VMG takes the shortest path to
forward a packet. Policy route allows the VMG to override the default routing behavior and alter the
packet forwarding based on the policy defined by the network administrator. Policy-based routing is
applied to outgoing packets, prior to the normal routing.
You can use source-based policy forwarding to direct traffic from different users through different
connections or distribute traffic among multiple paths for load sharing.
The Policy Route screen let you view and configure routing policies on the VMG. Click Network Setting >
Routing > Policy Route to open the following screen.
Figure 65 Network Setting > Routing > Policy Route
The following table describes the labels in this screen.
Table 39 Network Setting > Routing >Policy Route
LABEL
Add New Policy
Route
#
Status
Name
Source IP
Source Subnet
Mask
Protocol
Chapter 9 Routing
DESCRIPTION
Select Enable to activate this DNS route.
Enter the domain name of the DNS route entry.
Enter the subnet mask of the DNS route entry.
Select the WAN connection through which the VMG forwards DNS requests for this domain
name. WWAN means the wireless 3G interface.
Click this to save your changes.
Click this to exit this screen without saving any changes.
DESCRIPTION
Click this to create a new policy forwarding rule.
This is the index number of the entry.
This field displays whether the DNS route is active or not. A yellow bulb signifies that this DNS route
is active. A gray bulb signifies that this DNS route is not active.
This is the name of the rule.
This is the source IP address.
his is the source subnet mask address.
This is the transport layer protocol.
VMG3925-B10C/B30C User's Guide
149
Advertisement
Table of Contents
