Restore Factory Settings; Maintenance And Cleaning - HomeMatic HmIP-FAL230-C6 Installation Instructions And Operating Manual

stored. If you do this, you will lose all your settings.
To restore the factory settings of the floor heating actua-
tor, please proceed as follows:
• Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-
ange (see fig. 7).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
12

Maintenance and cleaning

The product does not require any maintenance.
Maintenance and cleaning
77