Adding A New Floor Heating Actuator - HomeMatic HmIP-FAL230-C6 Installation Instructions And Operating Manual

Floor heating actuator – 6 channels, 230 v
Hide thumbs Also See for HmIP-FAL230-C6:
Table of Contents

Advertisement

Available languages

Available languages

Start-up
seconds until the LED quickly starts flashing or-
ange (see fig. 7). Pairing mode remains activated
for 3 minutes.
Press and hold down the system button of the
Multi IO Box for at least 4 seconds to activate the
pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful.
If pairing failed, the device LED (A) lights up red. Please
try again.
6.4.3

Adding a new floor heating actuator

To add a new floor heating actuator to the system or to
the existing devices, please proceed as follows:
First pair the new floor heating actuator with an
existing one. Activate the pairing mode of the ex-
isting floor heating actuator. Therefore, press and
hold down the system button (A) for at least 4
seconds.
Activate the pairing mode of the new floor heating
actuator. Press and hold down the system button
(A) for at least 4 seconds.
The device LED (A) lights up green to indicate that
pairing has been successful. If pairing failed, the
device LED (A) lights up red. Please try again.
60

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hmip-fal230-c10

Table of Contents