Pairing With A Homematic Ip Multi Io Box - HomeMatic HmIP-FAL230-C6 Installation Instructions And Operating Manual

devices has to be activated first. To do this, proceed as
follows:
• Select the channel for pairing a device by press-
ing the select button (B) briefly (see fig. 7). Press
once for channel 1, twice for channel 2 etc. The
channel LED lights permanently for the corre-
sponding channel.
• Press and hold down the system button (A) for 4
seconds until the LED quickly starts flashing or-
ange (see fig. 7). The pairing mode of the selected
channel remains activated for 3 minutes.
• Press and hold down the system button of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful.
If pairing failed, the device LED (A) lights up red. Please
try again.
6.4.2

Pairing with a Homematic IP Multi IO Box

If you want to pair the floor heating actuator with a
Homematic IP Multi IO Box, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
Briefly press the select button (B) until the LEDs of
•
all channels light up green (see fig. 7).
• Press and hold down the system button (A) for 4
Start-up
59