Table of Contents
Advertisement
SC-F9300 Series
User's Guide
B
Press the d/u buttons to select Heater
Temperature, and then press the Z button.
C
Choose a value.
Press the d/u buttons to set the temperature.
D
When you press the Z button, the settings for
the currently selected media are updated, and the
Heating & Drying menu is displayed.
E
When you press the y button, the menu is closed
and the status display screen is displayed.
Note:
The time needed for the heaters to reach the
specified temperatures varies with the ambient
temperature.
Correcting Banding
When you want to correct banding during printing,
perform Feed Adjustment.
Buttons that are used in the following settings
A
Press the M button during printing.
The current adjustment value is displayed.
B
Use the d/u buttons to change the current value.
If the feed amount is too small, black bands (dark
stripes) will appear; adjust the feed amount
upwards.
Basic Operations
If, in contrast, the feed amount is too large, white
bands (pale stripes) will appear; adjust the feed
amount downwards.
C
Check the printing result. If you are not satisfied
with the results, use the d/u buttons to change
the value.
This updates the setting value of Feed
Adjustment in the currently selected media
settings.
D
Press the Z button to display the status display
screen.
Note:
If the setting is changed, the icon is displayed on the
control panel screen as shown below. To clear this
icon, carry out the following operations.
❏ Restart Feed Adjustment.
❏ Execute Restore Settings.
51
Advertisement
Table of Contents
