Table of Contents
Advertisement
SC-F9300 Series
User's Guide
E
Attach the chip unit supplied with the new ink
pack to the slider.
Check to confirm that the color of the label on the
slider matches the color of the label on the chip
unit when installing.
F
Hold the slider level and insert it, then lower the
lock lever.
c
Important:
Do not push the slider in with too much force.
Failure to observe this precaution could
damage the printer.
Maintenance
G
As shown in the illustration, shake the new ink
pack horizontally, about 5 cm to the left and
right, for approximately 15 times in 5 seconds.
H
Confirm that no warning or error is displayed on
the control panel screen, and then open ink inlet
cover of the slider.
When a warning or error is displayed, resolve the
warning/error according to the instructions, and
then go to the following operations.
I
Remove the ink inlet cap from the ink tank.
The method for removing the ink inlet cap differs
depending on the type of ink being refilled.
c
Important:
Remove the ink inlet cap slowly. If you remove
the cap too quickly, ink may splatter.
68
Advertisement
Table of Contents
