Table of Contents
Advertisement
The tear off position setting is set incorrectly.
The paper does not eject properly.
Cause
Your paper may be too long or too short.
You may be trying to feed too much paper
backward.
The paper size setting in your application or the
printer driver may not match the size of the
paper you are using.
Paper is jammed inside the printer.
The printer does not feed continuous paper to the standby position.
Cause
You have not torn off the printed pages before
pressing the Load/Eject button.
Correcting USB Problems
If you are having difficulty using your printer with a USB connection, read the information in this
section.
If your printer does not work correctly with the USB cable, try following solutions:
❏ Make sure that the cable you are using is a standard, shielded USB cable.
❏ If you are using a USB hub, connect the printer to the first tier of the hub, or connect the
printer directly to the computer's USB port.
Adjust the tear off position using the Micro Adjust function. See
"Adjusting the tear off position" on page 47 for more
information.
What to do
Make sure the page length of your paper is within the specified
range. See "Paper" on page 114 for information on the
continuous paper specification.
If you are using normal continuous paper, tear off the last
printed page and press the Load/Eject button to feed the paper
backward. If you are using labels, tear off the paper entering the
printer, and then press the LF/FF button to feed the labels
forward.
Check the paper size setting in your application or the printer
driver.
Clear the paper jam as described in "Clearing a Paper Jam" on
page 84.
What to do
Tear off the printed pages at the perforation. Then press the
Load/Eject button to feed the paper backward to the standby
position.
LQ-690II/LQ-690IIN
User's Guide
Troubleshooting
83
Advertisement
Table of Contents
