Media - Epson SureColor SC-F9330 Series User Manual

SC-F9300 Series User's Guide
Have you compared the printing result with
o
the image on the display monitor?
Since monitors and printers produce colors
differently, printed colors will not always match
on-screen colors perfectly.
Was a printer cover opened during printing?
o
Opening covers during printing causes the print head
to stop abruptly, resulting in uneven colors. Do not
open the covers while printing is in progress.
The print is not positioned properly
on the media.
Is the media loaded correctly and are the
o
margins correct?
If the media is not loaded correctly, the results may be
off center or part of the data may not be printed. You
should also check whether the correct options are
selected for Side Margin and Print Start Position in
the setup menu.
"Loading media" on page 27
U
"The Printer Setup Menu" on page 99
U
Is the media skewed?
o
If Off is selected for Media Skew Check in the setup
menu, printing will continue when the media is
skewed and data will appear outside the print area.
Set Media Skew Check to On in the Menu.
"The Printer Setup Menu" on page 99
U
Is the media wide enough for the print data?
o
Although printing normally stops if the print image is
wider than the media, data will be printed beyond the
edges of the media if Off is selected for Media Size
Check in the setup menu. Choose On for Media Size
Check in the setup menu.
"The Printer Setup Menu" on page 99
U
Problem Solver
Vertical ruled lines are misaligned.
Is the media wavy?
o
Certain types of media may develop waves under
some conditions (humidity and temperature) while
installed in the printer. If a wave has developed, press
the d button in the control panel to feed the media
and avoid the affected area. We recommend that you
lower the temperature and humidity to prevent
waves developing.
Is the print head misaligned?
o
If the print head is misaligned, ruled lines may be
misaligned accordingly. In this case, select Media
Adjust - Head Alignment in the media settings to
adjust a print head misalignment that occurs during
printing.
"Head Alignment" on page 50
U

Media

Media Jams.
Is media curled, folded, curved, creased, or
o
waved?
Cut and remove the curled, folded, curved, creased, or
waved part.
"Cutting Media" on page 43
U
Is media loaded just before printing?
o
The pressure rollers may crease media left in the
printer, or the media may also become wavy or curled.
Is the media too thick or too thin?
o
❏
Check the media specifications to determine
whether it can be used in the printer.
U
❏
For information on how to configure print
settings using the software RIP, contact the RIP
manufacturer.
Is Media Suction set too high?
o
In the media settings, reduce Media Suction (the force
that sucks media down the media path).
"Media Setting Item" on page 95
U
112
"Supported Media" on page 118