Drawing Of Table - JUKI IP-100A Engineer's Manual

19. DRAWING OF TABLE

W-W (E-1)
ø26
ø8.5
X-X (C-6)
(2 places)
V-V (B-6)
(2 places)
C1.5 to C2.5
(for the hinge side only)
Z-Z (D-5) T-T (D-7)
Y-Y (E-5)
(2 places) (2 places)
(2 places)
1.2±0.5
Y-Y rubber cushion installing
drawing for reference
148
− −
Dimension drawing in detail
Style of type : Helvetica Reg. Condensed
11
0.8 1 1 0.8
Thickness : 1.5
5x160=600
120˚
Thickness : 0.8
Thickness : 0.5
Thickness : 1.5
X-X rubber cushion installing
drawing for reference
A : 4 x ø3.4 on the bottom surface, depth 20
Condensed voided letters
(Drill a hole at the time of set-up)
B : Installing position of stopper for drawer
(on the reverse side)
C : JUKI logo type
D : ø16, depth 30
E : 9 drill x ø20 chamfered, depth 17
F : 2 x ø3, depth 10
G : 2 x ø3.4 depth 10 (on the bottom surface)
(Drill a hole at the time of set-up)
H : ø18 drilled hole
I : 2 x ø3 depth 10
J : 3 x ø13 drilled hole
K : Bird's nest prevention device (installing solenoid
valve) ø3.4 on the bottom surface, depth 20
L : Bird's nest prevention device (installing regulator)
ø3.4 on the bottom surface, depth 20
M : Bird's nest prevention device solenoid valve cord
Installing position of staples for passing air pipe
Part No. : 23544000