Table of Contents
Advertisement
13. SCREWS FOR ATTACHMENTS
The machine arm and bed are provided with screws that can be used for installing attachments for the
sewing machine. Locations and sizes of the screws are as shown below.
65.5
41.3
41.3
14. SPARE PARTS
1) Without the thread trimmer
Feed base spacer (Part No. : 10025906)
Enter this spacer between the feed base and the feed
dog when desired to increase the feed dog height in the
case where prevention of inactive feed at the overlapped
section, prevention of the material-turn at the overlapped
section or feed dog height adjustment when the
commercially-available feed dog is used.
2) With the thread trimmer
Use the following spacers (feed base, throat plate) if the
counter knife comes in contact with the feed dog when
performing the adjustment of feed dog height or feed
timing, or the commercially-available feed dog is used.
Feed base spacer
(Part No. : 10025906)
Throat plate spacer
(Part No. : 22503908)
3) Exclusive grease
* Exclusive grease (23640204) is applied to the parts for which lubrication is necessary except the
lubricating section. Never use any grease other than the exclusive grease.2. (Accessories : JUKI
grease A tube Part No. : 40006323 containing 10g)
Addition of the grease is not necessary for general use of the sewing machine. In the case where the
sewing machine is used under the specially severe conditions, it is effective to periodically fill the
exclusive grease (once in one to two years).
Ruler stop seat
22902605
13.5
9/64 40-thread depth 6
11/64 40-thread
19
19
70
73
19
57.5
3/16 32-thread
37
2x3/16 32-thread
depth 7
* S p a c e r s a r e s u p p l i e d a s
accessories for A-SS and A-DS.
Spacers are installed at the time
of delivery for A-DU and A-SU.
2x3/16 28-thread
depth 6
48.5
20
depth 6
19
127
−
−
6x3/16 28-thread
depth 7
2x3/16 32-thread
32
32
10025906
t = 0.5
22503908
t = 0.5
To keep
the space
Advertisement
Table of Contents
