Table of Contents
Advertisement
Operation
Note: Item numbers in ( ) will be referenced in the Parts Illustration and Parts List on pages
Like all mechanical tools, reasonable care must be used when operating machine. Inspect machine work
area and machine before operating. Make sure that all operators of this equipment are trained in general
machine use and safety.
Starting the Engine
Put oil in engine before starting!
•
See engine manufacturer's instructions for type and amount of oil and gasoline used. Engine
•
must be level when checking and filling oil and gasoline.
Engine Speed: Engine speed is fixed.
Fuel Valve: Move fuel valve to "ON" position.
Choke: Found on engine above fuel "ON" switch.
Pull: Pull the starting rope to start engine.
Forward/Reverse Controls: See page 6 "Operator's Controls".
WARNING: Do not operate if excessive vibration occurs. If excessive vibration occurs, shut engine off
immediately and check for damaged or worn blade, loose blade bolts, loose engine or lodged foreign
objects.
Handling and Transporting
•
Use loading ramps to move unit into truck or trailer for transport.
•
Do not operate the blade when loading.
•
Never load this machine by hand.
Cutting Operation
The unit performs best when the ground is wet. If possible, sprinkle the work area several hours before
starting.
CAUTION: Use extreme care when operating the blade. Inspect the work area for foreign objects that
could cause damage to the unit or injure the operator if struck by the blade. Never operate the blade with
bystanders in the work area.
General Operation
Position the turf cutter outdoors on sufficiently firm, flat soil. Read the instructions provided by the engine
manufacturer in the relative manual and follow them carefully to prevent situations from arising which may
endanger either persons or the machine.
TIP: When using the machine for the first time, execute maneuvers on flat ground free of foreign objects
to become more comfortable with machine operation. After switching on the engine, follow the instructions
given in the previous paragraph.
page).
WARNING: Do not adjust cutting depth while machine is in motion. Choose a cutting depth suitable for
the type of terrain the machine is to be used on.
Part No. 373507
Be mindful of the machine tipping forward (See Figure 9. on the following
8
16-34.
373507_A_HI
Advertisement
Table of Contents
