There Is Lint On My Clothes; There Is Static In My Clothes After Drying; The Drying Time Is Not Consistent; Water Is Found Around The Cabinet Cover When Opening The Door - Asko TLS752 XXL Operating Instructions Manual

Troubleshooting Guide
5. Problem: There is lint on my clothes.
Question
• Is your lint filter full?
• Did you properly sort your
load of laundry?
• Do your clothes have excess
static electricity?
• Did you overload your dryer? Divide your larger load into smaller loads.
• Did you place any paper,
tissue, or other similar
material in the load?
6. Problem: There is static in my clothes after drying.
Question
• Did you use Anti-Static
option?
• Did you use fabric softener? Try using a fabric softener to reduce static electricity.
• Did you over dry the load of
laundry?
• Are you drying synthetic,
permanent press and blends?
7. Problem: Inconsistent dry times and levels of dryness.
Question
• Are you using consistent
heat settings and consistent
load sizes
8. Problem: Water is found around the cabinet cover when opening the
door.
Question
• Is water found around
cabinet cover when opening
the door?
Please refer to the manual section on cleaning the lint filter, and please
confirm that the lint filter is clean. It is important that the lint filter is clean
before each new load of laundry.
In order to reduce the amount of lint in a load of laundry, sort lint
producers (like a fuzzy white cotton towels) separately from clothes that
might catch lint (such as a pair of black linen pants).
See comments below under "There Is Static In My Clothes After Drying".
Sometimes a person might forget to take a piece of paper or a tissue out
of a pocket, and this paper, tissue, or similar material can cause excess
lint in a load of laundry.
Confirm that the pockets of pants, shirts, and other articles of clothing
are empty before washing and drying.
Try using a Anti-Static option to reduce static electricity build up during
drying cycle.
Over-drying a load of laundry can cause a build up of static electricity.
Try using a fabric softener or adjust your settings and use a shorter
drying time.
These materials can cause static to build up in a load of dried clothes.
Try using a fabric softener.
The drying time for a load will vary depending on the heat setting, the
type of heat used (electric, natural or LP gas), the size of the load, the
type of fabrics, the moisture of the clothes and the condition of the
exhaust ducts and lint filter.
This is normal because it is condensed moisture from the drying process.
Customer Care Center
1-800-898-1879
www.askousa.com
What to Do
What to Do
What to Do
What to Do
23