Komatsu PW160-7K Series Operation And Maintenance Manual page 95

OPERATION
2. CREEP SPEED SELECTOR SWITCH
This switch (2) is used to set the travel mode to creep.
CR lights up: Creep mode travel (0-1.5kph).
To cancel creep speed, press Hi/Lo switch.
REMARK
When creep speed is selected the mode is displayed in the
centre of the screen for 2 seconds before returning to the normal
screen display.
3. HIGH/LOW SPEED SELECTOR SWITCH
This switch (3) is used to set the travel speed to 3 stages.
Lo lights up: Low-mode travel
Hi lights up: Hi-mode travel
At lights up: Auto mode travel
When the engine is started, the speed is automatically set to the
last value before engine was stopped.
Each time that the switch is pressed, the display changes
Lo→Hi→At→Lo in turn.
When travelling in auto mode (At), if more travel torque is needed,
such as when traveling on soft ground or on slopes, the speed
automatically switches to low speed (Lo), so there is no need to
operate the switch.
EXPLANATION OF COMPONENTS
Display portion
Display portion
95