Table of Contents
Advertisement
OPERATIONS AND CHECKS BEFORE STARTING ENGINE
3. Lower the safety lock lever to the UNLOCK position, fold the
work equipment, and raise it 40 - 50 cm from the ground.
4. Raise the stabilisers/dozer blade (when fitted). See Section
on operation of dozer & outriggers.
5. Ensure that the wheel brake is off by depressing service
brake pedal (29) to release latch mechanism (29a).
6. Release the front axle suspension lock, using automatic sus-
pension lock switch.
For details, see "AUTOMATIC SUSPENSION LOCK
SWITCH (101)".
7. Select travel speed using switch. According to the ground
conditions and type of operation required, as follows:
for details, see "CREEP SPEED SELECTOR SWITCH (95)"
Creep mode: see "CREEP SPEED SELECTOR SWITCH (95)":
for fine control speed is restricted to 2.5 km/h.
REMARK
Creep can be engaged from any other mode by pressing the
Creep button.Press High / Low speed select switch to dis-engage
Creep.
Creep mode will only engage fully when the machine comes to a
stop.
Lo mode: for travelling on rough surfaces and on steep slopes (up
or down), e.g. work sites. Speed is restricted to 10 km/h
REMARK
Lo mode will only engage when machine speed is below 10
km/h
Hi mode is for high speed travel, on smooth surfaces with slopes
up to 5 degrees.
Auto mode: for travelling on roads or job sites with varying terrain.
Do not use auto mode on steep downhill slopes
use Lo mode
172
WARNING
LOCK
-
OPERATION
UNLOCK
29
29a
Advertisement
Table of Contents
