CyberPower OL6KRTMB Installation And Operation Manual page 35

Smart app online ups system
Table of Contents

Advertisement

USING THE UPS SYSTEM CONT.
LCD Setting Configuration Cont.
CONFIGURE
SUBMENU
Signal Inputs
Charger Check
With Transformer
Backfeed Check
Reset ReplaceBAT
IP Address
Reset Load Energy
This function can't be set when Manual Bypass, Generator Mode or Converter Mode is enabled.
1
UPS has no bypass when Generator Mode is enabled.
2
UPS has no bypass when Converter Mode is enabled. This function can only be set before the UPS is on.
3
Silencing Audible Alarms
1.
Press any of the four function buttons on the LCD module.
Note: the alarm cannot be turned o for a "Battery Low" condition. This condition will still result in an
audible alarm.
2. Change the "Audible Alarms" option to "Disable" in the LCD screen and it will no long give an audible
alarm for any malfunction.
Manual Battery Test
Select "Activate" in the "Battery Test" option of the LCD screen and the unit will perform a manual
battery test.
AVAILABLE SETTINGS
[Disable] [EPO] [ROO]
Sets [EPO] (Emergency Power O ) to shutdown the
UPS remotely when the contact is open.
Sets [ROO] (Remote On/O ) to turn On the UPS
remotely when the contact is close and turn O the UPS
remotely when the contact is open. The On/O power
button on front panel will be disabled when set to [ROO].
[Disable] [Enable]
Sets [Disable] or [Enable] to constantly monitor the
charger function.
[Disable] [Enable]
Sets [Enable] when UPS install with transformer.
[Disable] [Enable]
Sets [Enable] to active Backfeed connector function.
[Activate?]
Manually reset the Battery Replacement date.
[Mode:DHCP] [Mode:Manual]
[IP Address] [Subnet Mask] [Gateway] (for
[Mode:Manual])
Select [Mode:Manual] to set [IP Address] [Subnet
Mask] [Gateway] to network interface (RMCARD)
or select DHCP to set automatically.
[Activate?]
Reset Load Energy Consumption (KWH) value.
©2020 Cyber Power Systems (USA), Inc. All rights reserved. All other trademarks are the property of their respective owners.
DEFAULT SETTING
Disable
Disable
Disable
Disable
None
Mode:DHCP
None
None
29

Advertisement

Table of Contents
loading

Table of Contents