Table of Contents
Advertisement
USING THE UPS SYSTEM CONT.
LCD Setting Configuration Cont.
CONFIGURE
SUBMENU
ECO Mode
1
Manual Bypass
UPS Diagnostic
Audible Alarms
EBM Number
Wiring Fault
NCL Control
AVAILABLE SETTINGS
[Disable] [Enable]
[V Range= +/-15%] [V Range= +/-10%] (for [Enable])
When ECO mode is enabled the UPS will check the
following specifications of Bypass quality
(1) Bypass voltage is inside the [V Range= +/-10%]
(default setting) or [V Range= +/-15%].
(2) Bypass frequency is inside the +/-3Hz range of
output nominal frequency.
[Disable] [Enable]
When performing UPS maintenance, the user
can manually transfer the connected load to
Bypass without interrupting the output to the
connected equipment.
[Battery Test] [Alarm Test] [Indicator Test] [Fan Test]
[Activate?]
Starts a manual battery test, UPS will operate 10
seconds on Battery mode to check battery condition.
Starts a manual Alarm test, buzzer will sound for
5 seconds.
Starts a manual Indicator test, UPS will light all LED
and LCD background 5 seconds.
Starts a manual Fan test, UPS will operate fan with full
speed 5 seconds.
[Disable] [Enable] [Only Battery Low]
User can [Disable] or [Enable] the buzzer sound and
also can set [Only Battery Low] to have alarm only
when battery low on battery mode.
= [0] [1] [2] [3] [4] [5] [6] [7] [8] [9] [10]
Sets the actual EBM (extended battery modules)
number to get the correct estimated runtime.
[Disable] [Enable]
Sets [Disable] or [Enable] the auto checking of Input
wiring fault.
[Outlet On] [Outlet O ]
Sets Non-Critical Load (NCL) [Outlet On] or [Outlet
O ] directly. When the user sets NCL [Outlet O ] ,
the NCL output power will turn o directly.
©2020 Cyber Power Systems (USA), Inc. All rights reserved. All other trademarks are the property of their respective owners.
DEFAULT SETTING
Disable
V Range= +/-10%
Disable
[Battery Test]
None
Enable
0
Disable
Outlet On
27
Advertisement
Table of Contents
