CyberPower OL6KRTMB Installation And Operation Manual page 30

USING THE UPS SYSTEM CONT.
LCD Information Readout Cont.
INFORMATION
MENU ITEMS
Date & Time
Next BATT
Change
IP
Subnet Mask
Gateway
MAC
LCD Event Log
The UPS will record the five most recent system events in the Event Log.
1. Press the "ENTER" button to enter the "Main Menu".
2. Press the " " and " " buttons to scroll to the "Event Log" option.
3. Press the "ENTER" button to select the "Event Log" submenu.
EVENT LOG SUBMENU
(X)
4. Press the " " and " " buttons to scroll through the "Event Log." The UPS will record events listed in the
table below.
5. Press the "ESC" button to return to UPS Status.
EVENT CONTENT
High O/P V
Low O/P V
Output short
Bus Fault
Over Temp
Wiring Fault
O/P Overload
Over Charge
Charger Failure
Battery Low
Load Over Set%
DATA
DISPLAYED
- - - - / - - / - - - -:- -
XXX / XXXX
XXXXXX
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX
XX-XX-XX-XX-XX-XX
Event date and time followed by event description.
The UPS has detected Inverter voltage too High.
The UPS has detected Inverter voltage too Low.
The UPS has detected output short.
The UPS has detected DC Bus too High or Low.
The UPS has detected internal temperature too High.
The UPS has detected the input line/ neutral wire are reversed or without ground wire.
The UPS has detected Output Watt or VA are too High.
The Battery has been charged too High voltage.
The Battery Charger has malfunctioned.
The Battery has been discharged to low level.
The UPS has detected Output Watt or VA has exceeded user set parameter.
©2020 Cyber Power Systems (USA), Inc. All rights reserved. All other trademarks are the property of their respective owners.
Displays the present Date & Time
Displays the next Battery Change Date & Time
Display the network IP address
Display the network Subnet Mask
Display the network Gateway
Display the network card MAC address
DESCRIPTION
DESCRIPTION
DESCRIPTION
24