Before Removing The Sd Card - Pro-face GP-4400 Series Hardware Manual

Installation and Wiring

Before Removing the SD Card

154
Do not remove the SD Card while it is being accessed. Doing so could corrupt the
data on the SD Card. Before removing the SD Card from the GP unit, make sure you
run the following procedure to stop SD Card operation.
NOTE:
When the GP unit is in offline mode or in screen transfer mode, you cannot stop
SD Card operation. Return to RUN mode to stop the SD Card.
When the SD Card removal process is complete, the GP unit's SD Card Access
LED is off. Confirm the lamp is off, then remove the SD Card.
For instructions on how to stop SD Card operation, refer to the GP-Pro EX
Reference Manual, "Safely Detaching the SD Card or USB Storage Device".
Step Action
1 Either touch the top-right then the bottom-left corner, or the top-left then
bottom-right corner of the panel (within a 40 pixel area) in 0.5 seconds.
2 In the system menu, touch the SD Card icon.
3 In the "Remove SD Card?" message, touch [Yes].
4 When the GP unit completes the removal process, the SD Card icon
disappears from the system menu.
5 Touch the Close icon to exit the system menu.