Oce Eco Solvent CS9060 User Manual page 82

4.7.1 MediaType menu
Setup item
Media
4.7.1.1 User media menu
Notes
•
If non-compatible media is used, the following problems may occur:
Media detection error
o
Slant, snag and wrinkle of media
o
Media jams
o
Optimum printing quality cannot be obtained due to blots, blurs and dirt of ink.
o
End detection of roll media cannot be performed, etc.
o
The problems caused by the use of non-compatible will not be covered by the warranty and repair
expenses will be paid by the customer.
For details, contact your Océ representative.
Setup item
Type 1 to 30
Setting Value
Type 1 Set up the media type for printing.
It is possible to set 30 different user settings as
Type 2
"Type 1-30" for printing.
...
[Enter] key: Shift to the next hierarchy.
Type 29
refer to: User media menu
Type 30
[Cancel] key: Save the setting value and shift to
— the previous hierarchy.
refer to Setup menu
Setting Value
Set up the print mode according to the used print
data or print speed.
Print mode
•
Various settings on the Media feed compensation
can be set.
PF Adjust
•
Set up the Pre Heater temperature.
•
Pre Heater
Set up the Platen Heater temperature.
•
Fixer (platen)
Set up the After Heater temperature.
•
Dryer
Set up whether the heater is preheated while in
standby mode.
StandbyHeating
•
Set up the vacuum fan operation
•
Vacuum Fan
•
—
82
User's Guide Océ CS9060 printer
Chapter 4 : Handling the printer
Description
Description
[Enter] key: Shift to the next hierarchy.
refer to Print mode menu
[>] key: Shift to the next hierarchy.
refer to Dist. Adj menu
[Enter] key: Shift to the next hierarchy.
refer to Pre heater menu
[Enter] key: Shift to the next hierarchy.
refer to Platen heater menu
[Enter] key: Shift to the next hierarchy.
refer to After heater menu
[Enter] key: Shift to the next hierarchy.
refer to StandbyHeating menu
[Enter] key: Shift to the next hierarchy.
refer to Vacuum fan menu
[Cancel] key: Shift to the previous hierarchy.
refer to Media type menu
AP-75770 – Rev 1.1 -19/11/2007,