Oce Eco Solvent CS9060 User Manual page 135

The wrong media size is set during initialization
No. Possible cause
Are you using the
1
recommended media?
Is the media loaded at
2
an angle?
When the media is set,
3
does it curl upward?
Is the printer used in an
environment other than
4 the one specified, such
as near an air
conditioner?
Are you using media
5 that has been printed
on already?
Media jams frequently occur
Notes
•
If non- recommended media is used, correct media feeding cannot be assured.
No. Possible cause
Are you using the
1
recommended media?
Is the media used in an
2 environment other than
the one specified?
Are you using old
3
media?
Are you using folded or
4
wrinkled media?
Does the media bend?
5
The media veers during printing.
No. Possible cause
Are you using the
1
recommended media?
Is the loading position
2
of the media correct?
Is the roll media set
3
correctly?
Remedy
Use the recommended media.
Set the media straight.
Straighten the media or set a new media.
Only use the printer in an environment that is
specified for use.
Use a new media.
Remedy
Use the recommended media.
Use the media in a dedicated environment.
Replace it with new media.
Use the recommended media. When using media
other than the dedicated one, set the Vacuum Fan
menu.
Remedy
Use the recommended media.
Set the media correctly.
Set the roll media correctly.
135
User's Guide Océ CS9060 printer
Chapter 6: Troubleshooting
Reference
Setting roll media
Setting roll media
Loading roll media
Reference
"Cautions on
handling media"
"Replacing roll
media"
"Panel setup menu"
Reference
Setting roll media
Loading roll media
AP-75770 – Rev 1.1 -19/11/2007,