Oce Eco Solvent CS9060 User Manual page 109

5.1.6 Cleaning the wiper
(1) Cleaning time
Clean the wiper once a week or when blurs or incompleteness in printing remains after the head cleaning.
Notes
•
Use the cleaning stick when cleaning the wiper.
Step 1 : If the printer is switched ON, make sure that:
•
Printing or other operations are not in progress.
•
The display on the operation panel is in the normal state.
Step 2 : Display the CR Maintenance menu on the operation panel.
Step 3 : Press the [Menu] key on the operation panel.
•
"Menu 1: Setup>" is displayed on the operation panel.
•
The operation panel shifts to the setup menu display.
Step 4 : Press the [>] key on the operation panel.
•
"Set1: MediaType" is displayed on the operation panel.
User's Guide Océ CS9060 printer
Chapter 5: periodical maintenance
109 AP-75770 – Rev 1.1 -19/11/2007,