Step 5: Entering Monitor Mode And Testing - Omron F160 Operation Manual

Understanding Setting Operations
CHECK
CHECK
2-3-5

STEP 5: Entering Monitor Mode and Testing

2-3-5-1 Performing Test Measurements
Results are not output via the parallel interface in Monitor Mode. Change to
Run Mode to output the results.
Always save the condition settings to flash memory after they are set. The set-
tings will be cleared when the power is turned OFF if they are not saved
beforehand. (Refer to page 86.)
Perform a test to confirm that inspections will be performed according to the
set conditions.
The measurement results can be referred to when adjusting the precision of
the judgement and the measurement time. The results are not output to the
parallel interface or serial interface and so the test can be performed with the
F160 only.
1
SHIFT+
Perform test
measurement
Measurement time
SHIFT+ ENT
SHIFT+ ESC
1. Press the TRIG Key on the Console or turn ON the STEP signal.
One measurement will be executed.
2
Judgement
Adjust judgement
precision
By region,
position compensation
3
Adjust
measurement time.
Use the help function if the
Help
inspection is not correct.
Display The type of screen display
settings (freeze or through) can be changed.
Section 2-3
6
STEP
35