System Settings
3-9-4
Switching Menus
The F150 features 2 menus: Auto Menu and Expert Menu. Use
the following procedure to select which Menu is used when the
power to the F150 is turned ON.
Procedure
3-9-5
Startup Scene and Mode
Use the following procedure to set the startup scene and mode
that will be used when the power is turned ON.
If the F150 is set to start in Run mode for the scene where the
desired measurement conditions are registered, measurement
of objects can be started by simply turning the power ON.
The default setting is for scene 0 and Monitor mode.
58
2. If the following conditions hold, the number of stored images
will not exceed 22.
Image memory: Set to only NG
Last measurement was OK.
1
Go to SYS/Switch menu.
2
Select the desired menu.
3
Select End to enter the setting and to exit this screen.
Section
3-9