Step 6: Display; Step 7: Monitor Mode And Run Mode - Omron F160 Operation Manual

Setting Inspection Conditions
CHECK
2-4-6

STEP 6: Display

CHECK
2-4-7

STEP 7: Monitor Mode and Run Mode

2-4-7-1 Entering Monitor Mode
CHECK
Entering Monitor Mode from Set Mode
58
Select the destinations for data output under SYS/Output settings. Refer to
page 286.
Figures, characters, data, and other information can be added to the screen
display in Monitor and Run Modes. Up to 32 pieces of information can be
added for each scene.
This section gives an outline only. Refer to SECTION 4 Detailed Setting
Operations (page 225) for display details.
The same settings are used by both Camera 0 and Camera 1. Separate set-
tings cannot be made for each Camera.
This section explains how to check if measurements are being correctly per-
formed with the set measurement conditions using Monitor Mode, and how to
make actual measurements using Run Mode.
Use the following procedure to check that measurements are being correctly
performed with the set measurement conditions.
The key allocations for the Console Keys used to make input can be changed.
In the following explanations, it is assumed that the key allocations are at the
default settings. If they are not, adapt the procedure accordingly. Refer to
page 301.
1. Display the Set Mode Screen.
0.Scn 0 =SET=
Adjust
Position
Measurement
Expression
Display
2. Press the ESC Key to leave Set Mode and enter Monitor Mode.
0.Scn 0 MON
---- ---ms
Freeze
Section 2-4