Connection To The Factory Head Unit - r.LiNK CI-RL3-MIB92 Manual

2.3. Connections to the factory head-unit
Remove the head-unit.
Connect the female HSD+2 connector of the enclosed4pin HSD
picture signal cable to the video-interface's male HSD+2 connector.
Disconnect the female 4pin HSD connector of the vehicle harness at the
Rear-side of the head-unit and connect it to the interface's male 4pin HSD connector.
Note: If required, the marked lugs of the
female 4pin HSD connector have to be
cut off! Further, the colour of the female
4pin HSD connector may vary between
pink and grey, depending on the installed monitor.
Connect the female 4pin HSD connector of the enclosed 4pin HSD picture signal cable to the
previously become free male 4pin HSD connector of the head-unit
(colours may vary!).
Remove the female Quadlock connector of the vehicle
harness from the rear of the head-unit and connect the
previously clipped out white female 12pin connector
(see graphic) to the male 12pin connector of the
enclosed PNP harness.
Clip in the female 12pin connector of the PNP harness in the previously become free position
of the female Quadlock connector, before finishing the Quadlock reconnection at the rear of
the head-unit.
Version 24.07.2018 CAM(V97)/(V30) CI-RL3-MIB92