Disable Gvrp; Port Vlan Commands; Set Port Vid; Set Acceptable Frame Type - ZyXEL Communications ZyXEL Dimension GS-4012F User Manual

This command turns on GVRP in order to propagate VLAN information beyond the switch.

42.4.5 Disable GVRP

Syntax:
This command turns off GVRP so that the switch does not propagate VLAN information to
other switches.

42.5 Port VLAN Commands

You must configure the switch port VLAN settings in config-interface mode.

42.5.1 Set Port VID

Syntax:
where
<VID> =
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.

Figure 197 vlan1q port default vid Command Example

ras (config)# interface port-channel 1-5
ras (config-interface)# pvid 200

42.5.2 Set Acceptable Frame Type

Syntax:
where
<all|tagged>
Chapter 42 IEEE 802.1Q Tagged VLAN Commands
no vlan1q gvrp
pvid <VID>
Specifies the VLAN number between 1 and 4094
frame-type <all|tagged>
=
Specifies all Ethernet frames (tagged and untagged) or only tagged
Ethernet frames.
GS-4012F/4024 User's Guide
291