Configuring General System Settings - FLIR Lorex NR800 Series Instruction Manual

13 Using the Main Menu
NOTE
• The mirror hard drive must be as large or larger than primary hard drive to backup all recordings.
• HDD mirroring begins from when mirror hard drive is installed and configured.
• Two hard drives must be installed in the system to use HDD mirroring. For details on installing hard
drives, see 19 NR800 Series Hard Drive Installation, page 168.
To set up hard drive mirroring:
1. From the Main Menu, click
2. Click the Type drop-down under the second hard drive and select Mirror HDD.
CAUTION
Setting a hard drive for mirroring erases all data on the hard drive. This step cannot be undone.
3. Click OK to apply changes. Click Yes to confirm. The system will format the hard drive
and restart.
4. When the system restarts, click
5. Under Channel, select the channel you would like to enable for mirror recording, then
check Mirroring. Repeat the process for any additional channels.
6. Click OK to save changes.

13.3.23 Configuring General System Settings

You can use the General menu to configure miscellaneous system settings.
#LX400021; r. 7.0/42449/42450; en-US
and then click Storage>HDD Manager.
and then click Storage>Schedule>Record.
72