Configuring Hard Drive Warnings; Configuring Network Warnings - FLIR Lorex NR800 Series Instruction Manual

13 Using the Main Menu
To control alarm output devices:
• To enable alarm output devices, select Schedule or Manual for each device you would
like to enable. Select Stop to disable the alarm output device. Click OK to save
changes.
• To manually disable activated alarm devices, click OK under Alarm Release.

13.3.12 Configuring Hard Drive Warnings

Hard drive warnings will notify you if an issue is detected with the hard drive.
To configure hard drive warnings:
1. From the Main Menu, click
2. Under Event Type, select the hard drive event you would like to configure.
• No Disk: No hard drive detected.
• Disk Error: A hard drive error has been detected.
• Disk Full: The hard drive is full or almost full. You can enter the percentage of disk
space remaining that will trigger a warning under Less Than (e.g. when less than
10% of the hard drive is empty, trigger a warning). Disk Full warnings will not occur if
overwrite is enabled.
• All: Configure warnings for all hard drive events.
3. Configure the responses the system will take when the selected event occurs:
• Show Message: Show a popup message on the monitor.
• Alarm Out: Check the box to activate alarm output devices (not included) and se-
lect the alarm output devices (not included) will be activated when the selected
event occurs.
• Latch: Enter the number of seconds an alarm will activate after the selected event
occurs.
• Send Email: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 13.3.5 Configuring Email Alerts, page 57).
• Buzzer: Check to activate the system buzzer.
4. Click OK to save changes.

13.3.13 Configuring Network Warnings

Network warnings will notify you if there your system loses connection to the Internet or lo-
cal network or if there is an issue on your network.
#LX400021; r. 7.0/42449/42450; en-US
and then click Event>Warning>HDD.
64