Rear Panel (Nr800 Series) - FLIR Lorex NR800 Series Instruction Manual

4

Rear Panel (NR800 Series)

NR8081
1. Power input: Connect the included AC power cable.
2. On / Off switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
5. VGA: Connect a VGA monitor (not included) to view the system interface.
6. Audio IN/Audio OUT: Service only; not supported.
7. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
8. R232: Service only; not supported.
9. USB port(s): Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
10. Alarm block: Connect alarm/sensor devices (not included).
NR8163 / NR8326
1. Power input: Connect the included AC power cable.
2. On / Off switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
5. Audio IN / Audio OUT: Service only; not supported.
6. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
7. USB port(s): Connect a USB mouse or USB thumb drive (not included) for data back-
up or firmware updates.
8. eSATA: Connect a self-powered external eSATA HDD (not included) to extend the stor-
age capacity of the system or for data backup.
9. Alarm block: Connect alarm/sensor devices (not included).
10. VGA: Connect a VGA monitor (not included) to view the system interface.
#LX400021; r. 7.0/42449/42450; en-US
8