Troubleshooting - German pool PAC-215 User Manual

Troubleshooting

SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are
displayed on the appliance display.
If Is Displayed What Should I Do?
The appliance is fitted with a frost protection device to
avoid excessive formation of ice.
The appliance starts operating again automatically when
LOW TEMPERATURE (frost prevention)
the defrosting process is completed.
If this is displayed, contact customer service centre.
PROBE FAILURE (sensor damaged)
Empty the internal safety tank, following the instructions in
the "End of season operations" paragraph.
FULLTANK (safety tank full)
P.24
Troubleshooting
PROBLEM
CAUSE
The appliance does not • There is no current
switch on
• It is not plugged in
• The internal safety device has
tripped
The appliance works for a • There are bends in the air
short time only
exhaust hose
• Something is preventing the air
from being discharged
The appliance works, but • Windows, doors and/or curtains
does not cool the room
open
• There are heat sources in the
room (oven, hairdryer, etc)
• The air exhaust hose is detached
from the appliance
• The technical specification of the
appliance is not adequate for the
room in which it is located
During operation, there • Air filter clogged
is an unpleasant smell in
the room
The appliance does not •The internal compressor safety
operate for about three device prevents the appliance from
minutes after restarting it being restarted until three minutes
have elapsed since it was last
turned off
The following message • The appliance has a self
diagnosis system to identify a
appears on the display:
number of malfunctions
/ /
SOLUTION
• Wait
• Plug into socket
• Wait 30 minutes, if the problem
persists, contact customer service
center
• Position the air exhaust hose
correctly, keeping it as short and
free of kinks as possible to avoid
bottlenecks
• Check and remove any obstacles
obstructing air discharge
• Close doors, windows and cur-
tains, bearing in mind the "tips for
correct use" given above
• Eliminate the heat sources
• Fit the air exhaust hose in the
housing at the back of the appli-
ance
• Clean the filter as described
above
• Wait. This delay is part of nor-
mal operation
• See the SELF-DIAGNOSIS
Chapter
P.25