Care And Maintenance - German pool PAC-215 User Manual

Operating Instructions
Continuous Draining (fig.20)
While using the unit in dehumidifier mode, continuous drainage is recommended.
1 .Unplug the unit from the power source.
2. Remove the drain plug. While doing this operation some residual water may spill so please prepare a
pan to collect the water.
3. Connect the drain hose (1/2" or 12.7mm, maybe not supplied ). See diagram.
4. The water can be continuously drained through the hose into a floor drain or bucket.
5. Turn on the unit.
19
Drain outlet
Drain cap
Drain pan (prepared by customer selfs)
NOTE
Please be sure that the height of and section of the drain hose should not be higher than that of the
drain outlet, or the water tank may not be drained. (fig.21 and fig.22)
21
20
Drain cap
Drain hose
Drain outlet
22
P.22

Care And Maintenance

Before cleaning or maintenance, turn the appliance off by pressing the
or remote control, wait for a few minutes then unplug from the main socket.
CLEANING THE CABINET
You should clean the appliance with a slightly damp cloth then dry it with a dry cloth.
• Never wash the appliance with water. It could be dangerous.
• Never use petrol, alcohol or solvents to clean the appliance.
• Never spray insecticide liquids or similar.
CLEANING THE AIR FILTERS
To keep your appliance working efficiently,
you should clean the filter weekly.
The evaporator filter can be taken out like
fig. 23.
The condenser filters are formed by two
pieces.
Step1 :Take out one filter like fig. 24.
Step2: Take out other filter like fig.25-26.
Use a vacuum cleaner to remove dust accumulation from the filter. If it is very dirty, immerse in warm
water and rinse a number of times. The water should never be hotter than 40°C(104°F). After
washing, leave the filter to dry then attach the intake grille to the appliance.
Start-End Of Season Operations
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the earth
system is efficient. Follow the installation instructions precisely.
END OF SEASON OPERATIONS
To empty the internal circuit completely of water,
remove the cap (fig. 27).
Run off all water left into a basin. When all the water has been
drained, put the cap back in place.
Clean the filter and dry thoroughly before putting back.
button on the control panel
Watch the video clip
23 24
25 26
27
P.23