Table of Contents
Advertisement
39
PRE-ALARM
Set recording period in seconds just before motion is detected. Input up to 5 seconds of time.
Pre-alarm recording mode is always "continuous" at the recording speed that the user sets in the "Record"
menu.
MOTION AREA
Set the camera's motion area and sensitivity. The area can be selected by clicking a specific block and
dragging the cursor across the screen to select multiple blocks. Areas where motion detection is activated
will appear with a green border line. Unselected areas will be shown with a grey border.
Click [SET] in the "MOTION AREA" section to set area.
After selecting the area of motion, click [EXIT] menu(③) and then click [SAVE] button(
change.
To set all channels with the same condition, click [SELECT ALL] button(②) and click [SAVE] button(
save the change.
Note
Motion detection area and sensitivity should be set, properly, in consideration of the actual motion
happened in the site.
○ 1
) to save the
A
E
A
○ 1
) to
A
E
A
Advertisement
Table of Contents
