Digital Watchdog DW-VAC42T Quick Start Manual

4 CH 8 CH
DW-VAC42T DW-VAC82T
DW-VAC43T DW-VAC83T
DW-VAC44T DW-VAC84T
DW-VAC46T DW-VAC86T
4 CH and 8 CH Models
16 CH Model
Username: admin Password: no password
WHAT'S IN THE BOX
CD (QSG + Manual) 12V DC and
1 Set
& Quick Start Guide Power Cable
Terminal Block
IR Remote Control 1 Set
and Rubber Mount
USB Mouse 1 Set
Attention: This document is intended to serve as a quick reference page for initial set-up.
It is recommended that the user read the entire instruction manual for complete and proper DVR usage.
Tel: 866-446-3595 / 813-888-9555
Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday
Quick Start Guide
Step 1 – CONNECTING THE DVR
1.
Mount and install all necessary cameras and external devices. Refer to their individual manuals for
additional information.
16 CH
2. Place the DVR in its final position. See installation tips below.
DW-VAC162T
DW-VAC163T
3.
Connect all necessary cables to the DVR
DW-VAC164T
DW-VAC166T 4. Once all additional devices have been properly connected to the DVR, connect the DVR to
an appropriate power supply. The DVR will boot up automatically.
1 Set
1 Pair
(2 Pieces)
SAFETY TIPS
1 Set
1. Make sure the cameras and the monitors are properly connected to the DVR.
2. The DVR should be placed in a dust and moisture free environment. It must never be directly exposed to
sunlight. Server room temperature is highly recommended to reduce the chance of overheating, which
may cause the DVR to become unstable.
3. During the boot up process, the DVR should not be interrupted by pressing any buttons on the mouse.
Do not unplug the power adapter or turn the DVR off during the boot up process.
4. A UPS (Uninterrupted Power Supply) is highly recommended to prevent damage to the DVR during a
digital-watchdog.com
power outage.
CAMERA
1 2 3 4
AUDIO IN
AUDIO IN/OUT
5 6 7 8
AUDIO OUT
VIDEO IN
Back Panel Ports may differ according to model
Step 2 – POWERING UP THE DVR
1.
When the DVR boots up, it will be in protective mode. This
means you will not be able to access the DVR's setup menu
until you enter the proper username and password.
2. To unlock the DVR, right-click anywhere on the screen. The
login screen will appear. (Default Username / Password:
admin / no password)
3. When the DVR boots up for the first time, you will be guided
through the Startup Wizard.
RS 485 SENSOR IN ALARM
OUT +
LAN
TV / SPOT
PAL VGA/SPOT
NTSC TV-OUT RS 485 SENSOR IN ALARM DC 12V
HDMI VGA OUT USB OUT -
HD
VGA
HD MONITOR VGA MONITOR USB MOUSE
Quick Start Guide
NETWORK PORT
PTZ CAMERA
CONTROL
ALARM POWER SUPPLY
INPUT/OUTPUT