Table of Contents
Advertisement
17
PTZ Operation
3.3
In order to operate a PTZ camera, the channel which is connected by PTZ must be in full screen mode.
To activate PTZ control, right-click the mouse button and select "PTZ" in the pop-up men as seen below, or
select PTZ icon
bottom-right corner of the screen.
PTZ Control
In PTZ mode, users can control PTZ cameras with the USB
mouse. While clicking and holding the left button, drag the
cursor up/down or left/rightward to move the camera's pan/tilt
position. The further away from the center the cursor is moved,
the faster the PTZ camera will move.
To move the camera to a preset position, click the present
position number at the bottom of the screen. The presets must
be set prior to selection.
Note
Full PTZ functions are available by using USB mouse, IR remote control, or keyboard controller.
ZOOM/FOCUS
Zoom in/out by rolling the wheel of mouse to up or downward. If user changes the mode
into "Focus" in the pop-up menu, focus can be controlled by rolling the wheel of mouse
as well.
PRESET
When the preset menu pops-up, select the preset number and click "Enter" button to
move to the corresponding preset position.
Maximum Preset number supported is 255 (It can be restricted by the number that PTZ
camera supports).
GUARD TOUR
When enabled, the camera will automatically switch positions according to the sequence of
presets set in the GUARD TOUR settings.
switching to full screen for the channel that the PTZ camera is connected to. If "GUARD TOUR" is shown
as disabled, check if PTZ camera setting is correct. (Please refer to "4.2.3 PTZ" for more information.)
Caution
User can set interval for each preset position.Some preset positions might be skipped in case
the camera cannot mechanically move or control focus within the set interval time. In this case,
it is recommended to make setting of the interval time longer.
in the menu bar. When it is in the PTZ mode, the
"GUARD TOUR" can be enabled on the pop-up meny after
icon is shown on the
Advertisement
Table of Contents
