Table of Contents
Advertisement
35
1) Make sure of serial communication with the PTZ camera through RS-485 port.
2) Select "Pelco-D" in the protocol list, and set address.
3) Click "Save" button to confirm this configuration.
PROTOCOL
Select the proper protocol of the connected PTZ camera.
BAUD RATE
Select the baud rate level from 2,400bps up to 57,600bps.
ADDRESS
Set the PTZ driver address of the connected camera. It should be the same as that of the PTZ.
CONTROL (The functions are depends on the PTZ model)
When the [SET] button is clicked, the OSD menu of the camera will appear on the monitor. Set the PTZ's
speed, preset, tour, auto pan, etc.
① Direction buttons: move camera up/down & left/right.
② M (depends on PTZ model): Show/hide camera's OSD menu on
the DVR monitor. Use the directional arrows to navigate the meny
options.
③ ZOOM/FOCUS/IRIS: Control IN(+)/OUT(-) for each function.
④ Speed: Change the PTZ speed (0~100) and apply it by clicking
[SET] button.
⑤ Preset
Set: Move the camera's position and zoom to the desired
position. Select the preset number using the
press the [SET] button. (The system supports preset the number
of preset from 1 to 255.
Move : Select the desired position with the
camera to the preset position of that preset number.
⑥ TOUR : Set the camera to move between preset positions in order. The camera will continuously run
until it is manually disabled.
⑦ AUTOPAN: Set the camera to move 360° in one direction. The camera will keep running the auto-pan
until is it manually disabled.
⑧ GUARDTOUR : Set the camera to move between selected presets in
a set order and interval. The camera will keep running the guard tour
until it is manually disabled.
Set : Set the Interval (Sec) and select the desired preset position.
Add to Sequence by clicking the
in the Sequence column indicating the preset number and the set
interval time.
button and then
button and click the [Move] button to move the
button. The preset wil appear
Advertisement
Table of Contents
