Problem
The
LED (2) is illu-
minated although dish-
washer salt has been
added.
The water is not running
or it is running only very
slowly.
The water is not running
off or only very slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher cannot
be operated.
The dishwashing results are not satisfactory
Problem
There are residues or
streaks on the dishes.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the door is
closed.
The buttons are locked.
Possible cause
The rinse aid is incorrectly
dosed.
There is no dishwasher salt.
The dishwasher salt is
clumpy.
Troubleshooting table
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Arrange the inlet hose properly so
that it is not kinked (see „Connect-
ing the inlet hose" on page EN-24).
Turn the water tap on completely.
Clean the filters (see „Cleaning the
filters" on page EN-21).
Lay out the outlet hose in the proper
manner (see page EN-24).
Have the door seal replaced (see
„Service" on page EN-31).
Have the defective hose replaced
(see „Service" on page EN-31).
Close the door.
Unlock the buttons (see „Button
lock / child lock" on page EN-20).
Solution
Adjust the dispensed dose (see
„Adding rinse aid" on page EN-11).
Add dishwasher salt (see „Adding
dishwasher salt" on page EN-12).
Stir the dishwasher salt using the
end of a spoon or similar.
Page EN-29