Dishwasher Operation; Preparation; Selecting The Dishwasher Programme; Intensive Cleaning - Hanseatic WQP8-J7636E User Manual

Dishwasher operation

Preparation

Requirements:
– You have read chapter „Safety" on page
EN-6 and understand all the safety notices.
– The appliance is set up and connected as
described in chapter „Installation, connec-
tion and commissioning" on page EN-23.
– Dishwasher detergents, rinse aids and
dishwasher salts and multitabs are added.
1. Open the tap completely.
2. Close the dishwasher door.
3. Press the button (18) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a short time, the programme display
reading ECO (1) will show.
Selecting the dishwasher
programme
It is recommended that you carry out
a test run before the fi rst dishwasher
cycle in order to remove residues from
the manufacturing process and in order to
ensure that the device functions perfectly.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
1. Select the suitable dishwashing pro-
gramme based on the "dishwasher pro-
gramme table", see page EN-16.
(1)
(6)
2. Press the P (13) button as often as re-
quired until the display shows the desired
programme symbol (1) and the pro-
gramme duration (6).
3. For the washing programme,
– if you wish to make further adjustments,
– launch it, continue with „Starting the
Additional options
You can combine the various dishwashing
programmes with additional options. The
additional options must be selected before
starting the wash programme.

Intensive cleaning

(17)
This
ther improve the cleaning results.
This option is not available with the pro-
grammes
• To switch the option
– on, press the button
– off, press the button again. The symbol
(13)
Dishwasher operation
continue with „Additional options".
dishwashing programme" on page EN-18.
(7)
option allows you
, and .
In the display, the symbol
light up.
will disappear in the display.
Page EN-17
to fur-
(17).
(7) will