Degree Of Water Hardness; Test Run - Hanseatic WQP8-7714I User Manual

Page EN-28 Installation, connection and initial commissioning
To adjust the door
– so that it is easier to open, turn the screws
in an anti-clockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.

Degree of water hardness

Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the phar-
macy.
Water hardness in
your household in
°dH
0-5
6-11
12-17
18-22
23-34
35-55
1. Obtain the appropriate setting from the
table above.
2. Open the dishwasher door.
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
Water hardness in
the dishwasher
H1
H2
H3
H4
H5
H6
1. Open the dishwasher door and switch
the dishwasher off using the button (8).
The LED (7) will light up.
(1)
(13)
2. Press and hold the
long as required until the display shows
the current water hardness (
3. Press the button (13) as often as re-
quired until the desired setting is dis-
played.
4. Switch the dishwasher off using the but-
ton (8).
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the device
functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
(7)
(8)
(13) button for as
H1 H6
to ).