Degree Of Water Hardness; Test Run - Hanseatic HG6085E127635W Manual

Page EN-28 Setup or under-worktop installation and connection

Degree of water hardness

Hard water will cause calcification within the
dishwasher. Also, more dishwasher deter-
gent will be required to clean the dishes. Soft
water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to a hardness level of "H3".
Adjusting the water hardness level
(9)
(10)
1. Close the dishwasher door.
2. If the appliance is switched on, switch it off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the
LEDs (9) and (10) flash alternately.
Please refer to the following table for the
relevant water hardness setting:
(13)
button (13) until
°dH LED display
0–5
6-11
12-17
18-22
23-34
35-55
3. Press the button (13) repeatedly until
the required hardness level is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the tap completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs will
illuminate briefly.
After a moment, the ECO programme LED
will light up.
Setting
H1
H2
H3
H4
H5
H6